| | |
REQUIREMENTS |
PRODUCT |
METHODOLOGY |
Concrete Slabs |
4mm Torch-On |
• Clean surface (Dust free)
• Saturate surface with bituprimer 88% for Best adhesion
• Fully bond by Heat Welding 4mm torch-on to surface
• Include welding to outlets and to vertical walls
• Overlaps to be 75mm, Butt joins to be 100mm, up-laps to be 100mm
• Saturate with Bitumen Silver UV protective agent |
Corrugated Roof
IBR (Inverted box rib)
|
Polyester / Glass fiber membrane applied to bolt heads, lap and butt joints |
• Clean and prepare area
• Coat surface with either bitumen or acrylic bonding liquid
• Lay Polyester membrane into liquid
• Re-coat surface with either bitumen or acrylic bonding liquid
• Finish with UV stable final coat |
Expansion Jointing |
Expanding Foam and Polyurethane systems |
• Clean out Expansion joint (Dust free)
• Clearwet dual surfaces
• Install PU-Foam into crevice 5cm deep
• Allow to dry approx 2 hours
• Extract excess with extracting tool
• Clean surface and apply primer
• Install colour matched polyurethane to surface
• Smooth polyurethane with application tool |
Patios & Balconies |
Cementitious latex based system |
• Remove debris from working surface
• Clearwet surface for application
• Apply cementitious substrate to area
• Overlay area with polyfelt non woven micro fiber material
• Re-apply cementitious curing agent solution to polyfelt micro fibre |
Showers & Bathrooms |
Cementitious latex based system |
• Remove debris from working surface
• Clearwet surface for application
• Apply cementitious ubstrate to area
• Overlay area with polyfelt micro fibre material uplap 2M
• Re-apply cementitious curing agent solution to polyfelt micro fibre |
Parapet walls |
Membrane Systems |
• Clean parapet walls (Dust free)
• Coat surface with either bitumen or acrylic bonding liquid
• Lay Polyester membrane onto liquid
• Re-coat surface with either bitumen or acrylic bonding liquid
• Finish with UV stable final coat or final colour |
Tanking |
3-4mm
Torch-On |
• Clean surface (Dust free)
• Saturate vertical surface with bituprimer
• Heat Welding 3-4mm Torch-On to vertical surface / foundation
• Overlaps to be 100-300mm dependant upon spec
• Preferably install softboard against waterproofing |
Tanking with Drainage |
3-4mm
Torch-On |
• Clean surface (Dust free)
• Saturate surface with bituprimer
• Heat Welding 3-4mm Torch-On to vertical surface / foundation
• Overlaps to be 100-300mm dependant upon spec
• Install 110mm Geo drainage pide for correct flow
• Install Polyproperlene material over pipe area
• Install drainage pide for correct flow
• Install 14-19mm drainage stone against wall / foundation
• Install 19mm ply / hard board against waterproofed area |
Damp Proofing |
Cementitious latex based system |
• Remove debris from working surface
• Clearwet surface for application
• Application of cementitious substrate to area
• Re-Apply to areas 3-4 times @35 degree angles to last |
