WATERPROOFING AFRICA, We Reign When It Pours

Main menu:

SILICONE WATER REPELLANT

PRODUCTS

SILICONE WATER REPELLANT is an invisible, deep penetrating, weather resistant, water and dirt repellent, which seals brick, stone, concrete and mortar surfaces against penetrating rain and water from garden irrigation systems, taps or down pipes.
On any porous surfaces such as pre-cast concrete walls or asbestos / Nu-Tech sheeting,
SILICONE WATER REPELLANT will prevent algae growth and subsequent discoloration.


PRODUCT STATISTICS
Colour:	Clear
Application:	Brush, roller or spray.
Coverage:	4-6m2/L
Total Solids:	+/- 12.5%
Specific Gravity:	+/- 1
Drying Time:	Allow three hours flash off before over coating.
Viscosity:	<10 Krebbs Units at 25ºC
Cleaning:	Mineral Turpentine
Flammability:	Flammable
Surface Preparation	All forms of surface contamination must be removed to ensure a smooth surface, free of moisture and loose material, or any other barrier to adhesion. Use a wire brush to remove any laitance and efflorescence.
Application	During application, ensure adequate eye protection (goggles). Evenly apply by using a brush or low pressure knapsack sprayer. Begin treating the surface from the highest point, working downwards. Wipe off any overspray on glass surfaces as well as window & door frames. Allow a three hour flash off period. Apply a second coat, this time working from left to right. To achieve maximum penetration, avoid treating surfaces while warm or exposed to full sunlight. Do not apply onto wet surfaces. Do not apply prior to cementitious coatings. Coverage – 4msq to 6msq per litre. Two coat application. Clean up with mineral turpentine. Do not apply if rain is imminent.